Best Tool For Removing Carpet Tack Strips

You should also remove the tack strip if it s less than 1 4 in.

Best tool for removing carpet tack strips.

If you are pulling up carpet from stairs. You may also need to remove your carpet if you have hardwood floors underneath that you would like to refinish. The installer needs a gap at least 1 4 in. Roll or fold the strip secure with duct tape and remove it from the room.

Pull the pry bar free and remove the putty knife if you re using one. Reinsert them beside the next nail on the tack strip and pop that nail out the same way. Removing old carpeting may be necessary to save labor costs if you are having your carpet replaced. Wide to tuck the edge of the carpet down against the baseboard.

Continue like this until you have. Continue pulling up carpet a few feet at a time and cutting it into easy to handle strips. At those points slide a pry bar under the tack strip. Pick somewhere to start either a corner or a break between two tack strips.

Some people have a hard time with this step but i ll show you how to remove carpet tack strips the easy way with three simple tools. Then tap it with a hammer until the tack strip pops up. Begin at the top of the stairs. Press the pry bar in order to begin lifting the tack strip.

Carpet tack strips can usually remain in place but look for rust rot or other damage. Use the 6 in 1 painter s tool and a hammer to lift one end of one of the strips. After pulling up your carpet you will most likely have tack strips left around the perimeter of the room.